Ajishlal Community Legend ✭✭✭✭✭
Reactions
Comments
-
Hi @MarkCheng Fortigate and Sonicwall are setup with interface based tunnels. On the Sonicwall you don't specify the subnets in the tunnel policy using this method, instead you create static routes or use OSPF to control the routing. You create a tunnel for the primary connection and a backup connection. So if the…
-
Based on my research "NCSI taskbar icon may report "no internet" on Windows 10 2004 devices that DO have internet access" is a known issue, for more information, please kindly refer to the following link:…
-
hi @Karl For resolving the WAN Dynamic IP issue while using the VPN client / Netextender, use DynDns service.
-
Hi @LannyE For clients in different subnets from DHCP server, we need to set DHCP relay agent, for example, if the DHCP server's IP is 192.168.1.x in subnet 192.168.1.0/24, then for subnet 192.168.2.0/24 and 192.168.3.0/24, you need to set DHCP relay agent on network devices. For the workaround, Try to apply below steps.…
-
Hi @Smilepoint_Group Try to enable the required TCP port through powershell and use below command to do that. netsh advfirewall firewall add rule name="Open Port 4444" dir=in action=allow protocol=TCP localport=4444 Once you apply the above command and check whether it's open or not. Test-NetConnection -Port 4444…
-
Hi @Reinder You have to configure one more additional WAN interface in your sonicwall and connect to the 4G modem LAN1 port & LAN2 connect to the HA unit.
-
Hi @Oahued Try to stop and start the MTA service. If you are using hardware appliance login to the ESA SSH and apply the below command From the Putty SSH Session, run the following commands: stop pmta start pmta If you are using software appliance, Open the Start Menu of the Windows Server, and Stop/Start all SES Services
-
Hi @Reinder Instead using the 4G USB modem, I would recommend to use the 4G LTE normal modem and insert your SIM. Then configure your 4G modem LAN interface for the Sonicwall primary & HA unit. So in this scenario you would get fail-over connection as well as it will support HA.
-
Hi @JohnG I bought it from FS.COM and it's Dell compatible as well as you can get it from flypro.com.
-
Hi @davetapley You can check the "Auditing records" in Firewall for the configuration changes record. It will give you the details since the last reboot. Navigate to Log-->Auditing Records. More more info: please see the KB:
-
Hi @MIS_ShopperWorld If your X2 port is responding / active, Check your Firewall Failover & LB configuration and make sure the X2 port is added in the Default LB Group.
-
Hi @gussr16, For SAP Router configuration, You would have to use the original port 3299. As I know that the SAP DATA center knows only 3299 and they wont connect to your custom external port as well as you have to enable ping service to the SAP ROUTER from the SAP Datacenter cluster. From WAN-LAN you have to open the TCP…
-
Hi @Garyb For that you would have to configure the Access rule accordingly. Your can follow the below KB for configuring the Access Rule;
-
Hi @Ericlangel in that case you might be follow the below steps to accomplish your task;
-
Hi @Ericlangel For example, under the X3 interface you configured the sub-interface for your voice Vlan, Then you would have to edit that specif port on the switch to enable portshield to X3. Once you did that, you will get new option to set that port to your Voice Vlan as as an access port. Once you did the above…