Comments
-
Hello @Alberto, It is essential to upgrade to 6.5.4.7-83n due to the vulnerability CVE-2020-5135. But, the issue ID GEN6-1249 is targeted on the next version 6.5.4.8. For now, kindly upgrade to 6.5.4.7, you would be either provided an HF on 6.5.4.7 or you can upgrade once 6.5.4.8 is web posted. But, for now kindly keep the…
-
Yes, @mrshahin. If the address group is used in the access rule then it can contain both IPv4 and IPv6 address objects. The NAT rules are different for IPv4 and IPv6 and such groups cannot be used in those rules. So, in your case, in should work fine. Thanks!
-
Hello @Ajishlal, I could not see anyone else reporting anything similar. But I would suggest reaching out to Support regarding this so that we can provide this info to the backend. Thanks!
-
Hello @Enzino78, Welcome to SonicWall community. I know that it is not possible to configure LAG for a SonicWall switch managed by the firewall UI (6.5.4.7 or 7.0.x). It is definitely on the roadmap. I am not sure about the ETA. May be someone from PM team might have that info. Including @TIJU in this discussion for the…
-
Please use the IP address assigned on the X0 interface as the gateway on all devices. Thanks!
-
Hello @Bman, Welcome to SonicWall community. I think this could be related to WAN miniport (IP) device on the Lenovo Thinkpad. Please take a look at the KB article below. I hope this helps! Thanks!
-
Hello @skunkworks, Welcome to SonicWall community. You can certainly change the subnet mask on the X0 interface and use the X0 IP as the default gateway on all machines in 192.168.0.0/22 subnet. You are right, once you make this change, the communication will directly take place through the switch and will not be sent to…
-
Hello @Simon_Ward, Welcome to SonicWall community. There was a reported issue on 6.5.1.1 and 6.5.2.1 where the downloads were interrupted and the packets were being dropped with the reason 'Drop Code: 139(IDP detection OOO Out of Buffers)'. If you are seeing something similar in the packet capture while performing the…
-
Perfect. Glad to know that the issue is taken care of. Have a good one!
-
Hello @AussieCraig, 6.5.4.7-83n is web posted for all Gen 6 TZ, NSA and SM 9k models. It should be available on mysonicwall account already. Thanks!
-
@slbowen, There is a reset button next to the power slot, you can hold that you 30-45 seconds and once the test light starts blinking you will be in safe mode. Please use this KB for reference. https://www.sonicwall.com/support/knowledge-base/how-can-i-put-the-sonicwall-into-safe-mode/170507123738054/ You can access the…
-
The only reason that it won't accept your previously configured username/password is if you booted with a backup configuration. I can't think of anything else that can cause this. Good that you have the settings back up taken, so you can follow the procedure mentioned before. Thanks!
-
Hello @slbowen, If you are getting incorrect username/password error, please reset the firewall to factory default configuration. You can then import the setting file (exp). The default credentials are admin/password. Thanks!
-
Hello @Darshil, This is fixed on 6.5.4.7-83n. Please check the following for more details. Thanks!
-
Hello @Ajishlal, Gen 5 devices are not affected by the vulnerability CVE-2020-5135. Thanks!