Comments
-
@Enzino78 , We do have some options called Guest Services that can be useful. Please take a look at this KB. Also, moving this question to Mid range firewalls category. Thanks!
-
@AMOL , What error message are you seeing on the browser? I would suggest running a packet capture for the source you are testing from and see if any packets are being dropped by the firewall. You can use the following filter. Navigate to INVESTIGATE | Packet monitor - Settings tab: Uncheck everything - Monitor Filter tab:…
-
Understood. Let us know how it goes! Thanks!
-
Yes, it does. Please use this datasheet for more details about Gen 7 TZ devices. Thanks!
-
@Ehsan, The maximum local users supported for TZ 370 is 250 users. You can check these values by downloading the TSR. Thank you!
-
Amazing. Glad I could help! Have a good one!
-
@Jürg, Welcome to the SonicWall community. Have you tried this from a different browser? Also, the error points to a server-side error. Kindly reach out to the support team for further help. Thanks!
-
@jwwskymaster , Welcome to the SonicWall community. If the VPN is not getting established over the wireless Hub, I do not think the problem could be with the proposals as the same proposals work fine over the wired internet. Please check the logs and if necessary perform a packet capture to check why the connection could…
-
@cameron_chapman , The remote network that is 10.20.0.0/16 is added in the destination field of the static route that you would need to create for this VPN. The 169.254.123.216/30 as the tunnel interface IP can be added from MANAGE | Network | Interfaces section as per the screenshot below. I hope this helps! Thanks!
-
@Alberto, You can restrict the IP that the end-user can access based on the VPN access section of the user. Since these are LDAP users, you might need to import them to the firewall and then apply those. Also, the ACL can be used if you would like to further restrict the service like only RDP or SMB for a specific IP…
-
@MSYFlyer, With a single static address, the port forwarding with work to one internal address based on the port number. As the NAT rules are arranged based on priority. If it is possible for you, then PAT (Port address translation) can be used where a different port can be used externally that gets NATted to the same port…
-
@SupportGFS, If you are already on the latest version, please reach out to support for further analysis. We definitely need to have some detailed testing for this issue. Thanks!
-
@Dsenora, The SD-WAN is not a licensed service and is available on all Gen 6 devices running 6.5.3.x and higher. Although, for the problem that you have mentioned, I do not think that SD-WAN will be helpful. SD-WAN is used to make efficient decisions based on Jitter, latency, and data loss and select the right VPN to…
-
@SupportGFS, You are right, once the app is bound it should not ask for the binding again. What firmware do you have on the firewall and what model are you using? Thanks!
-
@Marcooooo, I don't think this can be done automatically. We do have an option to logout the selected users, where all active users can be selected and logged out from the firewall UI. But, if the challenge is with the time, wouldn't a login time of 12 hours be better? The users that log in the morning can continue to…