TKWITS Community Legend ✭✭✭✭✭
Reactions
Comments
-
It sounds like you followed the very vague KB article. Have you tried changing any aspects of your bandwidth object and re-tested? Is this applied to an access rule that controls all of the internet traffic?
-
Nope, but digging around I found this: You have to love level one techs!
-
Post a more detailed description of your config and the issue. What have you tried? What VoIP provider are you using?
-
Did you try searching?
-
Have you checked out the following doc? Says LACP is not currently supported?
-
Do you have NAT or other policies associated with the interface or zone? Im going to guess yes because all your sub-interfaces are in the LAN Zone. That's probably your problem... Create a TEST Zone and change your problem sub-interface's zone to it. Then see if you can do anything else with it. Having essentially all of…
-
Why are you pointing your firewall to the pi-hole again?
-
Are you running the latest firmware version?
-
It's the canned response of Sonicwall support. Even if you open a ticket they will ask you to factory default the unit.
-
"I tried to delete the current one but that was not happening. I deleted the routing info also still could not delete the virtual adapter to create a new one. I have to delete or edit the current one as the tagged vlan for that circuit has changed. I can't edit adapter." Slow down. It's hard to follow what you have or…
-
Have you run a packet capture to see what is actually happening with the data?...
-
Have you considered checking out Microsoft's documentation?
-
IIRC once you L2 bridge interfaces you lose the ability to use port sheilds on other interfaces. This was one of the reasons I stopped using Sonicwalls wireless devices.
-
Thanks for bring this up.