Comments
-
Hi @ALBERTO, Thank you for visiting SonicWall Community. I would suggest you to check the Connections Monitor section on the SonicWall GUI to check the Bandwidth Consumed IP addresses. The results can be aligned based on the IP address by clicking the Source IP address column. The Connections Monitor option is available…
-
Hi @FELART45, Thanks for the screenshot. I would say this is the firewall's expected behavior for the scenario to drop further connections post the defined value on the access rule.
-
Hi @KAKOLLUKUMAR, I believe Classic Mode is no more with MSW. Just checked and confirmed. Sorry about that. The best way to address this is to contact our Support team and get the issue fixed. Support folks should be able to help you on this. Have a good one!!!
-
Hi @KAKOLLUKUMAR, Could you please try to obtain the Keyset using Classic Mode View on the MSW? Just give it a try and see if Keyset appears.
-
Hi @KAKOLLUKUMAR, Does this NSv not having Internet access to register? If yes, please try the steps listed in the below KB article to register it. Hope this will help.
-
Hi @KAKOLLUKUMAR, Thank you for visiting SonicWall Community. Did you not get a Serial Number and Auth Code when activating the Trail License for the NSv on the MySonicWall (MSW)? Could you please check once on your MSW?
-
Hi @FELART45, Thank you for visiting SonicWall Community. Yes, this would be an expected behavior if you have configured the access rule with specific Source IP address and Service set to Any. To overcome it, please specify the Service on the access rule based on the flooded port. This should do the trick. HTH. Let me know…
-
Hi @DISCONNECTED, Thank you for visiting SonicWall Community. Could you please check if the WANGroup VPN meant for GVC is enabled? Disabled the complete VPN feature by unchecking the box, Enable VPN and the run the test. The test would show UDP 500 is filtered. Likewise access rules, to deal with NAT policies use the…
-
Hi @NTI, Thanks for the case number. I see the TSR on the support case and it looks good with no violations. Next time, along with TSR I would recommend you to collect the tracelogs and system logs from the appliance and attach those to the support case for better dig on the issue.
-
Hi @Nat, I verified the resource and it looks like the HF is available for certain device models. Could you please approach the support team on your respective case number and check?
-
Hi @NTI, Thank you for visiting SonicWall Community. Are these TZ's a new deployment or settings copied from a SonicWall to these? Since when the issue persists? Did the support team not analyze the logs to locate the reason for the lockup? Please share the support case number in which you got assistance from our support…
-
Hi @Pmaria, Thank you for visiting SonicWall Community. Yes, you have followed the right KB article to achieve the setup as needed. Unfortunately, its not working with the right setup to be in place. In this situation, if I were at your place, I would do packet capture on the SonicWall based on the Source IP address to see…
-
Hi @MATT, Thank you for visiting SonicWall Community. Please ensure to have the Log Sub Category "Network Access" enabled under Log Category "Network". This should trigger the logs on the SonicWall for the rule blocking. Hope this helps.
-
Hi @KakolluKumar, Please find below KB article steps to activate the NSv trial from your MySonicWall account and you should be able to download the respective NSv OVA file from your MySonicWall account. Hope this helps.
-
Hi @KAKOLLUKUMAR, Thank you for visiting SonicWall Community. SonicWall NSv OVA image should be obtained from the MySonicWall account to which it is registered to and file is not available using direct download link. Are you having any difficulties with file downloading from MySonicWall? If yes, please explain.