Ajishlal Community Legend ✭✭✭✭✭
Reactions
Comments
-
Hi @RichardH Remove all connected cables expect the up-link cable. Then connect back one by one and observe the CPU & Memory usage. Suspecting loop or faulty cable.
-
Hi @Karl Please check your Sonicwall WAN interface MTU size. If its 1500, reduce it to 1468 and observe the connection status.
-
Hi @Jason_W , Try to configure the PRTG SNMP SONICWALL SYSTEM HEALTH SENSOR, It will give you the sonicwall health as same as below; Connection Cache Used CPU Usage Downtime Memory Usage
-
Hi @pinaldps, Create the default static route in your CISCO 9300. # ip route 0.0.0.0 0.0.0.0 10.10.50.1 Above command sets destination network to 0.0.0.0/0 that represents all networks. If you cannot do the ping from your Firewall subnet to the internal VLAN, You have to create static route in your Firewall too. For your…
-
Hi @Fabin, Most of this kind of the issue due to the ISP side. Recently i faced the same issue due to they configure the Fiber ONT data port with voice . So the same port if i use for pabx it will work as well data and I am getting half of the internet speed.
-
Hi @samaj UDP and ICMP Flood attacks are a type of denial-of-service (DoS) attack. They are initiated by sending a large number of UDP or ICMP packets to a remote host. As a result, the victimized system's resources will be consumed with handling the attacking packets, which eventually causes the system to be unreachable…
-
Hi @MattG You have to dedicate one interface for the GVC DHCP lease ( not dummy interface) and do not connect the interface physically with any device. For example: Creating the DHCP pool for the GVC. Then configuring the DHCP over VPN Once you done above configuration, Navigate to the VPN-->Settings-->WAN Group…
-
Hi @MattG Try below KB and let us know whether it's helped or not.
-
Hi @Steve can you share with us the configuration screen?
-
Hi @Steve , You have to do the configuration in Firewall/SMA not on the client side.
-
Hi @Steve, For that navigate to the SSL VPN-->Client Settings-->Configure-->Client settings page you can enable the "Create client connection Profile"
-
Hi @stack888 For resolving The Windows Remote Access Service (RAS) has encountered an error problem, Please follow the below step; Navigate to Windows Device Manager --> Network Adaptores and uninstall the WAN Miniport (IP) and WAN Miniport (PPTP) devices, then scan for the hardware changes. Once it done the hardware…
-
NSA 4600 AppFlow Dash also have information about the Threats.
-
Hi @Micah , Kindly address the subjected case to the correct person please. Since 2019 I am behind this request.
-
Any update??