Ajishlal Community Legend ✭✭✭✭✭
Reactions
Comments
-
@LAIT Follow below KB for configuring the GVC DHCP relay and try.
-
Mine also facing same pblm. 29th cloud backup missing
-
@Ehsan Try below step in your sonicwall and let me know. Navigate to Network-->Routing-->Route polices-->Add Source: Any Destination: cisco vlan group (address object group)( in your case 10.10.10.0/24 & 192.168.1.0/24) service : any interface: X2 Gateway: your cisco switch IP( 192.168.1.1) Matric: 1
-
@Ehsan brief me about your network structure otherwise its difficult to giveyou a solution. in your initial statement not mentioned the cisco router and the application server.
-
Hi @Ehsan I would like to know that, Your 10.10.10.0 /24 subnet is your internal VLAN which is configured in cisco switch? as per your above information, you have only 1 Internet connection (X1). In this case you dont need to create any next hope in cisco switch. instead that the default route is fine.( 0.0.0.0 0.0.0.0…
-
Hi @Tulasidhar If you want to see the auto added rules, you must have to disable that highlighted feature. then only it will reflect the auto added rules in your ACL. If you enable that feature, auto added rules will disappear and you can create your own rules.
-
Hi @Tulasidhar , You have to "Disable Auto-added VPN Management Rules" in diag page. For navigating to the diag page for Sonic OS 7; https://[ip-address]/sonicui/7/m/mgmt/settings/diag Once you reach diag page follow the below screen shot; Disable the highlighted function if it's enable.
-
@scottrell check if there any custom port configured for management interface access.
-
@Chris_has_questions Upload Firmware with Current Configuration. Follow the below screenshot;
-
Hi @Cis58 Yes it is possible. In IKE, Configure both end with Main Mode and dont use aggressive mode. Both end SA Life time value should be same.
-
Hi @stevmorr As per Sonicwall July 2021 Security bulletin, they are covered the MS Exchange Remote Code Execution vulnerability.
-
Hi @gmenon, Most probably this issue due to the default WAN GroupVPN policy. You need to make sure that the default WAN GroupVPN policy is enabled. Navigate to VPN >> Settings >> VPN Policies and make sure you enabled WAN GroupVPN Policy as shown in the below screenshot. If above steps is fine from your end; Check your…
-
Yes You can.
-
@OptimisTech Follow the below KB, Page No:372/558 (Configuring & using Zones and device profile.
-
@Teleporter recommended to downgrade to the working Firmware until you get the fix or patch from support.