Ajishlal Community Legend ✭✭✭✭✭
Reactions
Comments
-
@sluque Let me try to understand your scenario; You have NSA3500 unit with 2 LAN Subnet (One is virtual LAN) which you need to add into the new IPSEC VPN Tunnel? If this is the scenario, YES possible. Otherwise please elaborate little more about your exact requirement.
-
@sheadyman Did you add the user in SSLVPN Service group membership?
-
@Archon are you using Sonicwave AP for the WiFi connection?
-
I did the test and its worked. LAN-->VPN | LAN --> DMZ | VPN --> LAN | LAN --> VLAN.
-
Hi @Enzino78 Yes. If the Gateway is the Firewall for the both zone.
-
Hi @tejasshenai If Analyser / GMS is connected with Firewall, just disconnect and observe it. as well as do the below steps to identify the issue. 1) Disable logging for App Control Globally 2) Change the logging level to " Notice". 3) If not enabled the Logging App Control Globally, Check any category is enabled the…
-
Hi @Shan use the Netextender clean up tool to Uninstall the Netextender and clear all registry entry of the Netextender on the machine.
-
Hi @LEON Yes. The unit is registered under your MySonicWall account, you can renew the security subscriptions.
-
Check the Ping service is enabled and top priority in the Access rule LAN-->LAN: If it's not help do the packet capture and it will help you to identify the exact issue.
-
Yes Logs from NetExtender.
-
If its possible can you send the error logs?
-
@ITManagerLEF For resolving The Windows Remote Access Service (RAS) has encountered an error problem, Please follow the below step; Navigate to Windows Device Manager --> Network Adaptores and uninstall the WAN Miniport (IP) and WAN Miniport (PPTP) devices, then scan for the hardware changes. Once it done the hardware…
-
Hi @works2020 You have to configure NAT over VPN and follow the below KB;
-
@craeckor Follow the below KB for configuring the 6RD Tunnel in sonicwall.
-
Hi @Archon Make sure your IPS configuration as same as below. Disable the Low priority attacks.